Poco M4 Pro won’t turn on: how to fix it

How do you say? Your Poco M4 Pro no longer starts up and the screen stays black? Then this is the right article for you. The causes of what you have found could be innumerable but, despite this, we will still try to find a solution.

First of all, if you wanted to know what to do if the Poco M4 Pro does not start, it would be essential to understand if the behavior was found following a fall, a bump (perhaps accidental), or a dive or contact with water or liquids.

If this were the case, we would be faced with a hardware problem and, unfortunately, the only viable solution would be to contact a Poco official service center or a specialized laboratory capable of resolving the anomaly found.

If none of this had happened, it is likely that the reason why Poco M4 Pro remains with a black screen and does not turn on again, perhaps following an update, is simply software. In this case, make yourself comfortable and proceed with reading the article.

Little M4 Pro is dead and won’t turn back on

As mentioned at the beginning of the guide, the reasons why the Poco M4 Pro no longer turns on could be different. Fortunately, they are often easily solved in a few steps, and therefore in a short time, which do not require any specific knowledge.

Press the power key correctly

Probably not your case but better be sure. In fact, it happened that more users complained that their phone seemed dead when instead they pressed the power button incorrectly. So make sure you press the button correctly.

It might sound silly but trust me it isn’t. There are several cases in which people are unable to turn on the smartphone, perhaps due to the haste given the apparent problem of Poco M4 Pro, because they press the power button in the wrong way.

Try a forced restart

Want to know why the Poco M4 Pro shut down and won’t start anymore? Good question, let’s try to find out together! It may happen that the Poco M4 Pro’s screen stays black for several reasons, sometimes even following a software update.

In these cases, it is sufficient to perform a forced restart. To force restart the Poco M4 Pro you have to press the volume down and power key at the same time for 10-15 seconds, until you see the phone logo appear on the screen. At this point, you can release the keys.

We do not exclude that the sequence for doing the forced restart of Poco M4 Pro may be updated. If the previous one did not have the right effect try to repeat it, this time by pressing only the power key or the power key together with volume up.

If the same behavior occurs again, we advise you to reset Poco M4 Pro in order to have a clean and error-free software base. But don’t forget to make a full backup first to avoid losing important data and photos.

Perform a prolonged charge

Have the previous solutions failed and your Poco M4 Pro looks dead? So what to do when the Poco M4 Pro still won’t turn on? The problem could concern the battery, perhaps almost exhausted, which begins to show the first signs of failure.

Try plugging your phone into the charger (preferably a powerful one like the iPad’s) for a long time and check if the status LEDs show any signs of life. It is not excluded that the battery has gone under voltage, which is why it needs a prolonged charge.

Conclusion

Here we are at the end of our guide, in which we have shown you all the methods and solutions to fix the Poco M4 Pro that won’t turn on anymore. We hope that the article has been to your liking but above all, it has been helpful to you.

About admin

Check Also

download-mode-xiaomi

How to Flash Firmware With Xiaomi MI Flash Tool

These are instructions on how to use Xiaomi Mi Flash Tool to flash or install …

Leave a Reply

Your email address will not be published. Required fields are marked *