Galaxy A52 SM-A525 Full Firmware And Combination Files [Download]

SM-A525 Full Firmware And Combination Files

Samsung Galaxy A52 SM-A525 Full Firmware And Combination Files Collection

DOWNLOAD:

1. Samsung Galaxy A52 (SM-A525M)

2. Samsung Galaxy A52 (SM-A525M)

(Instructions) Use Odin to upgrade, downgrade, stock ROM, root, recovery for Samsung devices

I. Necessary tools 

2. Download and extract Odin

II. Steps to take

# Data backup:

You need to back up important data (contacts, messages, photos, videos, …) before proceeding with the Samsung Stock Firmware because maybe all data will be lost and cannot be restored.

# Boot your Samsung device into Download Mode:

  1. Turn off the device and start the phone to Download Mode  (Currently, new models have different key structures, so the way to download Mode is different)
    • Method 1: Press and hold 3 Home + Power + Volume Down keys, then press Volume Up if it’s necessary
    • Method 2: Press and hold 3 keys POWER + VOLUME DOWN + BIXBY
    • Method 3: Press and hold 2 keys VOLUME DOWN + VOLUME UP and connect the USB cable to the computer
    • Method 4: Press and hold 3 keys POWER + VOLUME DOWN + VOLUME UP
    • Method 5 (from Note 9 and up): Press and hold 2 VOLUME DOWN + BIXBY keys and connect the USB cable to the computer
  2. It may then be necessary to press Volume Up to confirm, you will get the device into Download Mode on Samsung devices which should look like:

Download Mode on Samsung devices

Note:   you can only flash with .tar or .tar.md5 rom/root/recovery file

# Proceed to flash ROM with Odin

# Proceed to flash rom on Odin

  1. ID: COM must be on, it means Odin is connected to the Phone
  2. Select the ROM file on Odin as follows:
    (for ROMs with 1 file, just select it in the AP section )
    • In the BL section, select the file BL_xxx
    • In the AP section, select the file AP_xxx
    • In the CP section, select the file CP_xxx
    • In the CSC section, select the file CSC_xxx
  3. Select the file PIT: select tab ” Pit “, click ” PIT ” and select the file * .pit (Note: 1 the new line was integrated into CSC’s PIT file should be able to skip this step)
  4. Click  Start and wait a few minutes until the PASS message is successful.

About admin

Check Also

Tecno KG5 Flash File Firmware (Stock ROM)

Tecno Spark 8 KG5

In the rest of this post, we will discuss how to flash Tecno Spark 8 …

Leave a Reply

Your email address will not be published. Required fields are marked *